www.domo-elektro.be DO7047S
21
BEFORE USING
Check whether or not the mains voltage specied on the appliance’s rating plate
corresponds with the mains power supply.
Fully unroll the electric lead before use.
Place the appliance on a sturdy, even surface or ironing board.
Never immerse the appliance in water or any other liquid.
The iron must always be set to ‘MIN’ before you place or remove the plug from the
socket.
Wait until the iron has cooled off completely before putting it away.
Never pull on the mains lead, always gold the plug itself.
To prevent overloading the fuse, never plug another appliance with an equal mains
voltage into the same electrical fuse group.
SAFETY INSTRUCTIONS
This appliance produces steam with a high temperature. Always take great care when
handling the appliance and warn others of the possible danger.
Only use the appliance for its intended purpose.
Make sure the electric lead does not come into contact with the (hot) metal soleplate
of the iron.
Always remove the plug from the socket before (re) lling the iron with water or when
you are not using it.
Do not attempt to repair the appliance yourself.
If the electric lead is damaged it must be repaired or replaced by the manufacturer or
by its after sales service centre or by a qualied person, in order to prevent all risk of
accidents.
Take good care if turning the appliance upside down; you can suffer burns through the
hot water in the reservoir, escaping steam or through touching the iron underneath.
If the iron is not functioning correctly, remove the plug immediately from the mains
socket and allow the appliance to be checked by the manufacturer, its service point or
a similarly qualied person.
Your iron has been designed for placing in a vertical position resting on its back end
when not in use. Never leave the iron unattended when plugged in. Never place the
iron on an unprotected surface, this includes in the vertical position resting on its back
end.
USING THE IRON THE FIRST TIME
Remove the plastic protecting the soleplate (if it is present) and clean the soleplate
with a soft non-abrasive cloth.
Some parts of the iron have been lightly greased, that will cause the iron to emit a
slight odour and a little bit of smoke when rst used. This is normal and will not take
place again.
Keep the soleplate smooth and avoid scratches. Do not iron over metal surfaces with
the soleplate: the edge of the ironing board, buttons or zips.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals